Purified genomic DNA from several human-associated microorganisms in the oral cavity was purchased from ATCC (Manassas, Protein Tyrosine Kinase inhibitor VA). Buccal swab lysates were prepared to generate a reference database for concordance studies as described above. PCR amplification reactions were prepared by combining 6 μL of GlobalFiler Express

primer mix, 6 μL of master mix, and 3 μL of buccal cell lysate to give a total reaction volume of 15 μL according to the manufacturer’s protocol [12]. For positive control DNA 007 (supplied in the GlobalFiler Express Kit, ThermoFisher Scientific) reactions, 6 μL of primer mix, 6 μL of master mix, and 1 μL of sterile water was combined and then 2 μL of control DNA 007 (2 ng/μL) was added. Thermal cycling was performed on the GeneAmp® PCR system 9700 (ThermoFisher Scientific) with a 96-well gold-plated silver block. Thermal cycling parameters used the 9700 max mode: enzyme activation at 95 °C for 1 min, followed by 26 cycles of denaturation at 94 °C for 3 s and annealing/extension at 60 °C for 30 s. A final extension step was performed at 60 °C for 8 min, followed by a final hold at 4 °C if the PCR products were to remain in the thermal

cycler for an extended time. Cycle number was increased to 27 when re-amplifying samples with partial profiles. Following thermal cycling, samples were prepared for capillary electrophoresis (CE) according to the manufacturer’s protocol with GeneScan™600 LIZ® v2 and 500 LIZ® size standards [12]. Separation was performed on a 16-capillary 3130xL Genetic Analyzer (ThermoFisher Scientific) using a 36 cm capillary array, HIDFragmentAnalysis36_POP4 MDV3100 nmr run module with dye Ribonuclease T1 set J6. If a sample yielded off-scale peaks it was rerun after decreasing injection parameters from 3 kV for 10 s to 2 kV for 5 s. The electrophoresis results were analyzed using GeneMapper ID-X v1.4 genotyping software (ThermoFisher Scientific) using a 20% global filter and the recommended analysis settings for GlobalFiler® Express v1.2 chemistry. Peak amplitude of 50 RFU (relative fluorescence units) was used as the peak detection threshold when analyzing data from all electropherograms. PCR

reaction mix for the RapidHIT System was prepared using the same ratios as suggested by the manufacturer [12]. The primer mix and master mix reagents were preloaded into two separate vials prior to insertion of vials onto the sample cartridges. 20 μL of primer mix plus 5 μL of sterile water was combined and added to one vial and 20 μL of master mix plus 5 μL of sterile water was combined and added to the second vial. The two vials were inserted onto the cartridge for each PCR reaction. Once the paramagnetic beads containing extracted, purified DNA were transferred to the PCR reaction chamber, the master mix and primer mix were dispensed simultaneously into the chamber. The total volume of the PCR amplification chamber was approximately 20 μL.